Task #8094
Updated by Nico Schottelius over 4 years ago
h2. Steps
* Upgraded firmware to version 4.3.13
* Configured them via unifi network
* Connect them to an IPv6 only network
h2. Result
* Access point turn off the radio shortly after booting
** Tested via "wpa_cli -i wlan0 scan" on computers nearby
** This does not happen if the AP gets an IPv4 address via dhcp
h2. Source of problem
It seems that the @uplink-monitor@ fails to detect the IPv6 uplink and according to https://community.ui.com/questions/UniFi-Controller-Connectivity-Monitor/630191eb-b6a1-4354-898b-610211197414 if there is no uplink, the radios are disabled.