How to configure Arista switches¶

• Table of contents
• How to configure Arista switches
  • Saving your changes
  • Entering conf mode
  • Setting password
  • Setting name
  • Creating a VLAN
  • Putting a port into a untagged vlan
  • Creating a port channel (= LACP = bonding)
  • Creating a port channel over multiple switches using MLAG
  • Upgrading a switch
  • Configuring MLAG
  • Configuring BGP

Saving your changes¶

If you don't enter write at the end, everything is lost after reboot.

write

Entering conf mode¶

enable
conf

Setting password¶

username admin secret <passwordhere>

Setting name¶

hostname <NAME>

Creating a VLAN¶

vlan <ID-OF-VLAN>
name <NAME-OF-VLAN>

Putting a port into a untagged vlan¶

interface EthernetXX
   switchport access vlan YY

Creating a port channel (= LACP = bonding)¶

• go to the interface that you want to be in the port-channel
• configure it

interface EthernetXX
   channel-group XX mode active

Creating a port channel over multiple switches using MLAG¶

interface EthernetXX
   channel-group XX mode active
   mlag XX

# this seems wrong: mlag can only confed on port-channel ?

And if you want to have tagged/trunk port:

   switchport mode trunk 

Upgrading a switch¶

• copy the image from usb to flash
• change the boot config
• don't forget to write
• reload

copy usb1:/EOS-4.14.4.swi flash:/EOS-4.14.4.swi
configure terminal
boot system flash:/EOS-4.14.4.swi
show boot-config
write
reload

Configuring MLAG¶

• Create a port channel for communication
• Configure the mlag over it
• Assuming the switches are connected by ethernet 47 and ethernet 48
• Assuming that the switches use vlan 13
• ZZ = ip suffix of the switch
• WW = ip suffix of the other switch
• mlagdomain = something local

interface ethernet 47
    channel-group 47 mode active

interface ethernet 48
    channel-group 47 mode active

interface Port-Channel47
   switchport mode trunk
   switchport trunk group mlag-aristas

vlan 13
   name mlag-aristas
   trunk group mlag-aristas

interface Vlan13
   no autostate
   ip address 10.3.4.ZZ/24

mlag configuration
   domain-id MLAGLOCALDOMAIN
   peer-address 10.3.4.WW
   local-interface Vlan13
   peer-link Port-Channel47

Configuring BGP¶

• XX = ip suffix

router bgp 209898
   router-id 0.0.0.XX
   bgp default ipv6-unicast
   maximum-paths 4
   bgp listen range 2a0a:e5c0:1:8::/64 peer-group ungleich remote-as 209898
   neighbor ungleich peer-group
   neighbor ungleich maximum-routes 12000