Managing OpenWRT » History » Revision 8

« Previous | Revision 8/33 (diff) | Next »
ll nu, 07/03/2020 01:09 PM

Managing OpenWRT

Installing and configuring Jool

  • You can use one of the known NAT64 prefixes from our networks (LINK!)
    • In the example below this is 2a0a:e5c0:2:10::/96
  • You need to have a /96 (or better: /64) routed to the openwrt
    • In the example below this is 2a0a:e5c0:17:1::/96
opkg install kmod-jool
opkg install jool-tools

# Load the kernel module
modprobe jool_siit

# The range which will be the target for the 2nd NAT (if needed to reach a v4 ip)
jool_siit -6 2a0a:e5c0:2:10::/96

# Pick a v6 range to translate TO and a v4 range to translate from
jool_siit -e -a 2a0a:e5c0:17:1::/96

# Accept Router Advertisements to keep the default address
sysctl -w net.ipv6.conf.all.accept_ra=2
sysctl -w net.ipv6.conf.default.accept_ra=2
sysctl -w net.ipv6.conf.eth0.accept_ra=2
sysctl -w

Enabling routing with router advertisements

  • By default ipv6 forwarding is on (good!)
  • By default accept_ra is 0
    • This does not set the route properly into the kernel -> routing is broken
  • Need to modify accept_ra to 2

Enabling SSH access on wan

Enable it in the web interface



Dropbear uci var (not tested):

    option GatewayPorts 'on' 

Updated by ll nu about 4 years ago · 8 revisions