Project

General

Profile

Actions

How to configure Arista switches » History » Revision 5

« Previous | Revision 5/15 (diff) | Next »
Nico Schottelius, 07/10/2019 05:28 PM


How to configure Arista switches

Saving your changes

If you don't enter write at the end, everything is lost after reboot.

write

Entering conf mode

enable
conf

Setting password

username admin secret <passwordhere>

Setting name

hostname <NAME>

Creating a VLAN

vlan <ID-OF-VLAN>
name <NAME-OF-VLAN>

Putting a port into a untagged vlan

interface EthernetXX
   switchport access vlan YY

Creating a port channel (= LACP = bonding)

  • go to the interface that you want to be in the port-channel
  • configure it
interface EthernetXX
   channel-group XX mode active

Upgrading a switch

  • copy the image from usb to flash
  • change the boot config
  • don't forget to write
  • reload
copy usb1:/EOS-4.14.4.swi flash:/EOS-4.14.4.swi
configure terminal
boot system flash:/EOS-4.14.4.swi
show boot-config
write
reload

Updated by Nico Schottelius over 4 years ago · 5 revisions