How to configure Arista switches » History » Revision 5
Revision 4 (Nico Schottelius, 07/10/2019 05:28 PM) → Revision 5/15 (Nico Schottelius, 07/10/2019 05:28 PM)
h1. How to configure Arista switches
{{toc}}
h2. Saving your changes
If you don't enter write at the end, everything is lost after reboot.
<pre>
write
</pre>
h2. Entering conf mode
<pre>
enable
conf
</pre>
h2. Setting password
<pre>
username admin secret <passwordhere>
</pre>
h2. Setting name
<pre>
hostname <NAME>
</pre>
h2. Creating a VLAN
<pre>
vlan <ID-OF-VLAN>
name <NAME-OF-VLAN>
</pre>
h2. Putting a port into a untagged vlan
<pre>
interface EthernetXX
switchport access vlan YY
</pre>
h2. Creating a port channel (= LACP = bonding)
* go to the interface that you want to be in the port-channel
* configure it
<pre>
interface EthernetXX
channel-group XX mode active
</pre>
h2. Upgrading a switch
* copy the image from usb to flash
* change the boot config
* don't forget to write
* reload
<pre>
copy usb1:/EOS-4.14.4.swi flash:/EOS-4.14.4.swi
configure terminal
boot system flash:/EOS-4.14.4.swi
show boot-config
write
reload
</pre>