How to configure mikrotik network equipment » History » Revision 5
Revision 4 (Nico Schottelius, 05/21/2020 03:22 PM) → Revision 5/32 (Nico Schottelius, 05/21/2020 03:24 PM)
h1. How to configure mikrotik network equipment
h2. Status
This document is **PRE PRODUCTION**.
h2. Setting up a newly arrived Mikrotik switch
This part is specific for mikrotik-crs326 devices and should
After arriving within 1 work day do:
* Unpack
* Find out which name the switch should have
** go to https://netbox.ungleich.ch
** search for crs326
** identify the last used number
** Create a new device
*** go to devices
*** devices
*** add
**** name: "mikrotik-crs326-XX"
**** device-role: a device role
**** device-type: CRS326
**** serial-number: <from the device>
**** site: placeX -
**** create
* Add a physical label with its name
** Do not continue before you have done that!
* configure your notebook with the ipv4 address 192.168.88.23/24
* connect to the crs326: @ssh admin@192.168.88.1@
* Configure the switch
** Set identity: @/system identity set name=mikrotik-crs326-XX@ # use the correct name
** Set password: @/user set admin password=@ # use the password for mikrotik in the place that you are, use password store
** Enable IPv6: @/system package enable ipv6@
** Reboot so that IPv6 is enabled: @/system reboot@
** Add a place indendent, unrouted IPv6 address: @/ipv6 address add eui-64=yes advertise=no interface=bridge address=2a0a:e5c0:1:c::/64@
** Get the assigned IPv6 address: @/ipv6 address print@
** Disconnect from the switch
* Assign your notebook the IPv6 address *2a0a:e5c0:1:c::23/64*
* Connect to the switch via IPv6
** Remove the IPv4 address 192.168.88.1 to avoid collisions with other switches: @/ip address remove numbers=0@
*** Verify: @/ip address print@
* Verify / update entries in netbox:
** Verify that the serial number is correct: @:put [ /system routerboard get serial-number ]@
** Netbox
*** go to the ipv6 prefix https://netbox.ungleich.ch/ipam/prefixes/216/
**** create a new ipv6 address
**** set the DNS name to *mikrotik-crs326-XX*
**** role = loopback